Using The Locking Clip - Evenflo Embrace Owner's Manual

Using the Locking Clip

To watch a video about installing a locking clip, go to
www.evenflo.com.
Locking Clip
Consult your vehicle owner's manual before
installing the locking clip.
WARNING
Remove locking clip from vehicle seat belt when
not used with a child restraint, or the vehicle seat
belt will not properly restrain an adult or child.
Serious injury could occur.
1
Remove the locking clip
convenience base.
Thread the seat belt through the base openings
the vehicle belt path, and buckle the seat belt.
Pull the shoulder belt
from the lap portion of the belt.
Use the locking clip with:
Lap/shoulder seat belt
combination that has a
buckle tongue that slides
freely along the belt
without locking into
place and is equipped with
an emergency locking
retractor (ELR).
Some ELR vehicle belts can
be switched so that they lock
when tightened.
T !
T !
IP
IP
Push down
on the base using
your foot or
knee.
from the slot in your
tightly to remove all slack
40
2
Hold the lap/shoulder belts together just behind the
free sliding buckle tongue
belt.
3
4
for
• If installing the convenience base with a vehicle seat
belt, return to page 22, Step 3.
• If installing the carrier (no convenience base) with a
vehicle seat belt, return to page 29, Step 4.
and unfasten the seat
While holding the belts and
buckle tongue
the locking clip
seat belt, and slide it into
place.
Note: Locking clip must be
placed within 13 mm
(0.5 in.) of seat belt buckle.
13 mm (0.5 in.)
Buckle the seat belt with
the locking clip
place.
41
, thread
onto the
in