GREAT PLANES Aviastar elite Instruction Manual page 26

Avistar has a removable hatch, we simply left it inside the
fuselage. It can be easily accessed by removing the hatch.
❏
7. Slide the spinner backplate onto the engine crankshaft
(or brushless motor prop adapter). Depending on the shaft
size of your engine or motor, you may need to enlarge the
hole in the spinner back plate. This can be done with standard
drill bits. However, to ensure the spinner rotates concentrically,
we recommend using a reamer (GPMQ5006 standard prop
reamer, GPMQ5007 metric prop reamer). Balance and install
the prop (ream if necessary) and thoroughly tighten it with the
prop washer and nut (see page 31 about balancing propellers).
❏
8. Install the spinner cone onto the backplate using the
included spinner screws. You may need to widen the prop
blade slots in the spinner cone with a hobby knife or rotary
tool if it does not fi t over the propeller.
❏
9. Fit the servo leads in the wings through the holes in
the underside of the wing panels. Optional fl ap servo leads
are shown.
❏
10. Insert the aluminum wing joiner tube into one of the
wing panels.
❏
11. Slide the wing panels together onto the joiner tube.
26