GREAT PLANES Aviastar elite Instruction Manual page 8

dried, install the servos into the openings using the screws
supplied with the servos.
❏
7. Thread a nylon clevis onto two 6-1/4" [159mm] pushrods
20 complete turns.
Builder's Tip
Installation of the clevises will be much easier using a clevis
installation tool (GPMR8030 or GPMR8035). Nylon clevises
are used on many models so this inexpensive tool will be a
valuable investment for all your future building.
❏
8. Center the positions of the ailerons by using small clamps
or tape to secure them inline with the fl aps. Slide a silicone
clevis retainer onto the base of each clevis. Attach the clevises
on the pushrods to the outer holes in the aileron control horns.
❏
9. With the ailerons and servos still centered, make a mark
on the pushrods where they cross the second outer holes in
the aileron servo arms.
❏
10. Bend each pushrod at a 90 degree angle at the marks
you made.
FasLink
Pushrod Wire
8
1/4" [6.4 mm]
Servo Arm