Installing The Tail Wheel - Pheonix Model SBACH Instruction Manual

Instruction Manual
6. Center the rudder servo using the radio and
install the servo arm. Attach the metal clevis to
the rudder servo arm.
M3 Clevis
7. Slide a crimp onto the cable, then pass the cable
through the threaded cable end. Pass the cable
back into the crimp and use crimping pliers to
secure the crimp to the cable.
8. Thread the metal connector to the metal clevis.
9. Attach the clevis to the rudder servo. There
should be light tension on each of the wires
when installed properly.
Note: Remember use thread locking compound
to secure.

INSTALLING THE TAIL WHEEL

1. The tail wheel set.
36
2. Remove the covering.
37
3. Secure the plate to the rudder.
4. Secure the tail brace to the fuselage.
38
8
SBACH
39
40
41
42