Table of Contents
Advertisement
Instruction Manual
Screw
INSTALLING THE SWITCH
1. The switch should be mounted on the fuselage
side.
2. Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
3. Secure the switch in place using the two
machine screws provided with the radio system.
Switch
open and close the canopy
57
58
Engine switch
59
Screw
60
INSTALLING and secure the wing
1. Glue the plastic part to the wing joiner.
2. Find the hole on the top of the wing by taking
measurements as picture below.
3. Drill through the mark you make with a 2.5mm
drill bit (Note: just through the wing joiner).
4. Secure the wing joiner using a 4mm x 35mm
wood screw.
12
SBACH
295mm
62
63
64
61
Advertisement
Table of Contents
