Installing The Tail Wheel - Pheonix Model Extra 330SC Instruction Manual

Instruction Manual
Crimp
Cable
Cable end
5. Thread the metal connector to the link ball.
6. Center the rudder servo using the radio and
install the servo arm. Attach the metal clevis to
the rudder servo arm.
7. Slide a crimp onto the cable, then pass the cable
through the threaded cable end. Pass the cable
back into the crimp and use crimping pliers to
secure the crimp to the cable.
8. Thread the metal connector to the metal clevis.
9. Attach the clevis to the rudder servo. There
should be light tension on each of the wires
when installed properly.
Note: Remember use thread locking compound
to secure.
Aluminum ball
Plastic ball link
Metal connector
35
36
37
M3 Clevis

INSTALLING THE TAIL WHEEL

1. The tail wheel set.
2. Remove the covering.
3. Secure the plate to the rudder.
8
EXTRA 330SC
Crimp
38
39
40
41