Installing The Tail Wheel; Installing The Main Landing Gear - Pheonix Model Katana 120 Instruction Manual

Instruction Manual

INSTALLING THE TAIL WHEEL

1. Using the knife cut away the wood from the
bottom of the rudder and slide the two nylon
clasps into the slot. Using C.A glue the nylon
clasps as shown.
2. Set the tail wheel assembly in place on the
plywood plate.
3. Drill 2,6mm pilot holes through the plywood
plate.
4. Secure the tail wheel bracket in place using two
3mm x 12mm screw.
5. Align the tail wheel wire so that the wire is
parallel with the bottom of the rudder.
22
23
24

INSTALLING THE MAIN LANDING GEAR

1. Nuts have been installed at the factory.
2. Install main landing gear into the fuselage using
(4) 4mm x 20mm socket head screws and flat
washers provided in the kit.
25
7
Katana 120
Wheel
Collar
26
27
28