Table of Contents
Advertisement
Instruction Manual
3. Glue the exit hole.
INSTALLING THE RUDDER SERVO
Install the rudder servo to the fuselage as shown.
INSTALLING THE RUDDER LINKAGES
The rudder is controlled by two metal cables.
Install the rudder linkages and cables as below.
1. Use a hobby knife to remove the covering from
the openings for the rudder control cables.
Remove the covering
2. The rudder has a block wood plate for mounting
the control horn. Two control horn in positioned
on both side rudder (left and right).
Glue C.A
29
30
31
Control horn
3. Install the control horn to the rudder.
Control horn
4. Slide a crimp onto the cable, then pass the
cable through the threaded cable end. Pass
the cable back into the crimp and use crimping
pliers to secure the crimp to the cable. Guide
the cable into the fuselage to the position for
the rudder servo.
Crimp
Cable
Cable end
5. Thread the metal connector to the link ball.
7
SBACH
Control horn
Screw
Control horn
Aluminum ball
Plastic ball link
Metal connector
32
33
34
35
Advertisement
Table of Contents
