Installing The Elevator Servo; Installing The Elevator Linkages - Pheonix Model SBACH Instruction Manual

Instruction Manual
Plastic screw

INSTALLING THE ELEVATOR SERVO

1. Remove the covering from over the precut servo
box on the elevator.
2. Install two servo to the elevator as shown.
Remove the covering
3. Remove the covering from the elevator to install
the control horn.
14
Remove the covering

INSTALLING THE ELEVATOR LINKAGES

15
The elevator linkages are assembled as shown below
16
. Repeat these step as installing the aileron
linkages.
17
5
SBACH
22mm
22mm
40mm
18
19
20