Installing The Vertical Stabilizer; Installing The Rudder Linkages; Installing The Rudder Servo - Pheonix Model Extra 330SC Instruction Manual

Instruction Manual

INSTALLING THE VERTICAL STABILIZER

1. Remove the covering from the bottom of the
rudder.
Remove the covering
2. Slide the joiner to the rudder.
3. Glue the exit hole.
CA Glue

INSTALLING THE RUDDER SERVO

Install the rudder servo to the fuselage as shown.

INSTALLING THE RUDDER LINKAGES

The rudder is controlled by two metal cables.
Install the rudder linkages and cables as below.
1. Use a hobby knife to remove the covering from
the openings for the rudder control cables.
28
Remove the covering
2. The rudder has a block wood plate for mounting
the control horn. Two control horn in positioned
on both side rudder (left and right).
29
3. Install the control horn to the rudder.
30
Control horn
4. Slide a crimp onto the cable, then pass the
cable through the threaded cable end. Pass
the cable back into the crimp and use crimping
pliers to secure the crimp to the cable. Guide
the cable into the fuselage to the position for
the rudder servo.
31
7
EXTRA 330SC
32
33
Control horn
34