Table of Contents
Advertisement
K
Push the unit into the printer unit
it clicks into place.
L
Remove the red sheet from the
photoconductor unit and remove
the two pieces of tape.
M
Close the right cover of the print-
er.
Note
❒ If the right cover of the printer
cannot be closed, it means that
the photoconductor unit has not
been properly installed. Slide
the photoconductor unit out
and push it into the printer
again until it clicks into place.
N
Close the front cover.
ZAEM370E
O
If the duplex unit is installed,
close the duplex unit .
P
Turn on the printer.
ZAEM410E
After one minute, the display ap-
pears.
ZAEM310E
Replacing the Photoconductor Unit
ZAEM380E
4
ZAEP270E
79
Advertisement
Table of Contents
