Table of Contents
Advertisement
Messages
Replace
PCU
Reset Duplex
Unit Correctly
Reset Fusing
Unit Correctly
Reset PCU
Correctly
Resetting Job...
Reset Tray#
Correctly
Setting Changed
Cannot Print
Waiting...
Warming Up...
Note
❒ If you cannot solve the problem by taking above actions, turn the power off
and then back on again. If this does not clear the error message, write down
the error number and the message, and contact your sales or service represen-
tative.
Error & Status Messages on the Operation Panel
Description
It is time to replace Photo Con-
ductor Unit Type 320.
AD380 (duplex unit) is not set
correctly.
There is no fusing unit, or the
fusing unit is not installed
properly.
There is no Photo Conductor
Unit Type 320, or Photo Con-
ductor Unit Type 320 is not in-
stalled properly.
Resetting print job.
There is no paper tray, or the
indicated tray is not set cor-
rectly.
# : Tray Number
Note
❒ This message appears only
for the default tray. ⇒ P.99
"Job Control Parameters"
The paper feed unit setting has
been changed, and the sample
print failed.
Printer is waiting for the next
data to print.
The printer is now preparing
for printing.
Comments
Replace Photo Conductor Unit
Type 320. ⇒ P.77 "Replacing
the Photoconductor Unit"
Set AD380 (duplex unit) cor-
rectly.
Install the fusing unit proper-
ly. For more information
about the fusing unit, see the
"Maintenance Kit Type 270
Replacement Guide" that
comes with the kit.
Install Photo Conductor Unit
Type 320 again. For more in-
formation about Photo Con-
ductor Unit Type 320, see the
"Photo Conductor Unit Type
320 Replacement Guide" that
comes with the photoconduc-
tor unit.
Wait for a while.
Set the tray correctly.
Configure the paper feed unit
correctly, and try again.
Wait for a while.
Wait until the printer is
warmed up.
4
47
Advertisement
Table of Contents
