Table of Contents
Advertisement
Messages
Reset Duplex Unit Correctly
Reset Fusing Unit Correctly
Reset PCU Correctly
Resetting Job...
Reset Tray# Correctly
Waiting...
Warming Up...
Error & Status Messages on the Operation Panel
Description
AD380 (duplex unit) is not set
correctly.
There is no fusing unit, or the
fusing unit is not installed
properly.
There is no Photo Conductor
Unit Type 320, or Photo Con-
ductor Unit Type 320 is not in-
stalled properly.
Resetting print job.
There is no paper tray, or the
indicated tray is not set cor-
rectly.
# : Tray Number
Note
❒ This message appears only
for the default tray. ⇒ P.99
"Job Control Parameters"
Printer is waiting for the next
data to print.
The printer is now preparing
for printing.
Comments
Set AD380 (duplex unit) cor-
rectly.
Install the fusing unit proper-
ly. For more information
about the fusing unit, see the
"Maintenance Kit Type 270
Replacement Guide" that
comes with the kit.
Install Photo Conductor Unit
Type 320 again. For more in-
formation about Photo Con-
ductor Unit Type 320, see the
"Photo Conductor Unit Type
320 Replacement Guide" that
comes with the photoconduc-
tor unit.
Wait for while.
Set the tray correctly.
Wait for a while.
Wait until the printer is
warmed up.
4
53
Advertisement
Table of Contents
