Table of Contents
Advertisement
Copying
Number of sheets that can
be set at one time
2
Select one of the following settings or keys:
• [Normal]: normal paper
• [Thick]: thick paper, post cards, adhesive labels, translucent paper
• [OHP]: OHP transparencies
• [Duplex]: Use for copying onto the reverse side of paper that has been al-
ready copied onto.
• [Duplex Thick]: Use for copying onto the reverse side of thick paper (105-
160g/m
verse side of paper".
• [Custom]: Use to specify a non-standard sized.
standard size paper with the bypass tray".
If the copy paper is bent, correct it before setting paper in the bypass tray. If
the bend is not corrected, a paper misfeed might occur.
When you copy onto OHP transparencies, you can select whether a blank slip
sheet is inserted between OHP transparencies.
When you set several sheets at a time, fan them to get air between them before
loading.
If the copy paper is curled, gently roll it to remove the curl.
When you copy onto OHP transparencies, insert them with the copy side up.
Do not stack copy paper above the limit mark.
When setting non-standard size paper, be sure to set the size after pressing
the [Custom] key.
Copying onto standard size paper with the bypass tray
Note
When you copy onto the reverse side of paper that has been already copied
onto,
P.48 "Copying onto the reverse side of paper".
42
Normal paper: 50 sheets
Thick paper, OHP transparencies: 30 sheets (smaller
than 8"
Adhesive labels: 30 sheets
Translucent paper: 50 sheets
Post cards: 25 sheets
P.48 "Copying onto the reverse side of paper".
2
, 28-43 lb) that has been copied onto.
13"), 15 sheets (8"
13" or larger)
P.48 "Copying onto the re-
P.44 "Copying onto non-
Advertisement
Table of Contents
