Warning Messages - Datamax M-class Mark II Operator's Manual

Warning Messages:

Warning Messages are displayed for a period of five seconds. If multiple warnings are detected,
the display will reflect the highest priority message.
Displayed Message
!
!
EPU!GBJMVSF!
!
!
HBQ!NPEF!
XBSOJOH!MPX!CBDLJOH!
!
!
!
HPPECZF!
!
!
!
IPTU!DIBOHFT!QFOEJOH!
!
!
!
MPX!WPMUBHF!
!
!
SUD!SBN!GBJMVSF!
!
!
!
JQ!EJTDPWFS!GBJMFE!
!
!
!
UFNQFSBUVSF!QBVTF!
Chapter 6 – Troubleshooting
Printer Warning Messages
Description
The printer has detected
defective printhead elements.
The printer measured only a
small difference between the
'empty' and 'gap' sensor
readings.
Power has been removed and
shutdown is in progress.
The host has pending
configuration changes that will
not take effect until a 'host
reset command' is issued.
The printer has detected a low
operating voltage.
The printer was unable to save
settings in permanent memory.
The printer was unable to find a
DHCP server.
A high printhead temperature
has been detected.
Action(s)
Replace the printhead if the print quality
becomes unacceptable.
Transparent backing or notched media
typically gives this indication. In this
case, there may be a slight delay in the
'Out of Stock' indication, after the media
supply is emptied; no action is required.
The printer power switch was turned
'Off', the line fuse has blown, or AC line
voltage has been lost.
To save changes, send a host reset
command (in DPL); or to discard
changes.
Possible low or fluctuating line voltage
level. Try moving the printer to another
outlet. When more than 50% black is
being printed, try reducing the Heat
Value or the size of the black image. If
the condition persists, call for service.
Possible faulty Main PCB. If the
condition persists, call for service.
This message does not effect the
operation of the printer and can be
cleared from the display by pressing the
button. To stop this from
FEED
reoccurring be sure the menu item 'IP
DISCOVERY' is set to 'DISABLED', see
Section 4.5.
No action required. Printing will resume
after the printhead cools.
63