Downloading Firmware And Fonts - Datamax M-class Mark II Operator's Manual

5 . 9 D o w n l o a d
5 . 9 D o w n l o a d
5 . 9 D o w n l o a
The operating programs and fonts for the printer are stored in Flash memory on the Main PCB.
When program updates and/or new features are added, they can be downloaded to the printer as
follows:
1. Identify the new version for your model of printer from the Datamax Web site at
www.datamaxcorp.com and download it onto your computer's hard drive or a floppy disk.
2. Ensure that the printer is connected to the host, (via parallel port only) and that the power is
'On.' Using the DOS copy command enter:
copy filename.dlf lpt1/b
Other programs (e.g., hyper-terminal and certain Windows® Driver programs) may also be
used to download this file.
3. The light will flash during the download.
READY
4. Following a successful download, the
perform a 'cold reset.' The previous printer setup will not be affected unless substantial
firmware data structure changes have occurred. Print a Database Configuration Label to verify
your new firmware version.
Following an unsuccessful download, the
will perform a 'warm reset' (both the
initialization). The original firmware will remain operational. If the printer fails to reset, toggle
the power 'Off' and 'On.'
Try re-sending the file to the printer. If the failure continues, check the following possible
causes:
An invalid or corrupted file is being downloaded - Ensure the file being downloaded is
correct and applicable for your printer model.
Possible communications error - Check the cable connection between the host and printer
and ensure that a quality, shielded cable is used.
Possible Flash memory problem - Call for service.
54
i n g F i r m w a r e
i n g F i r m w a r e
d i n g F i r m w a r e
READY
Chapter 5 – Maintenance and Adjustments
a n d F o n t s
a n d F o n t s
a n d F o n t s
(non-display printer firmware is .dlf extension)
Light will illuminate then the printer will
STOP
Light will illuminate then the printer
ERROR
and lights will be on during power-up
STOP