Cisco TelePresence MX200 Administrator's Manual page 39

Cisco TelePresence MX200 and MX300
Contents
Managing pre-installed certificates
for Edge provisioning
The list of pre-installed certificates that is shown on this
page in the web interface , contains certificates that will be
*
used when the video system is provisioned by Cisco Unified
Communications Manager (CUCM) via Expressway (Edge).
Only Edge infrastructure certificates will be checked against
this list.
If the Edge infrastructure certificate validation fails, the video
system will not receive the provisioning and not be registered.
Factory resetting the video system will not delete the list of
pre-installed certificates.
* The certificate and certificate issuers shown in the illustration serve
as examples. Your system will have other certificate(s).
D14850.12 MX200 and MX300 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface Web interface
Navigate to: Configuration > Security: Preinstalled CAs tab
System settings
www.cisco.com — Copyright © 2011–2015 Cisco Systems, Inc. All rights reserved.
39
Administrator Guide
Setting passwords Appendices
Viewing or disabling certificates
You can view a certificate, and
disable a certificate using the
corresponding buttons.
You can disable all the pre-
installed certificates, and use
a manually uploaded list of
certificates for verification instead.
See the Configuration > Security:
CAs page how to upload trusted
certificates to the video system
manually.