Classic Organ Works CMK-1 User Manual page 70

F0 00 20 1C dd 04 01 04 bb bb ss <data, 8-for-7 format> F7
Transfer Config Memory data. This message should be sent from the CMK in response to a request message.
dd:
bb bb: block-count within the sequence of saved data blocks' memory data, low-order 7 bits first. The
ss:
data:
F0 00 20 1C dd 04 01 08 bb bb aa aa aa ss <data, 8-for-7 format> F7
Update Config Memory data. The message with subcommand 08 will be generated by the external CMK
config application.
dd: identifies the device which is responding.
bb bb: block-count within the sequence of saved data blocks' memory data, low-order 7 bits first. The
aa aa aa: starting offset (21-bit address) of the config block (packed 7 bits).
ss: number of bytes of original data transferred in this block.
data: 8-for-7 coded bytes of data.
F0 00 20 1C dd 04 01 20 F7
Soft reboot CMK. The message with cause the CMK to resume operation and reload the PIC's EEPROM with
the contents of the FLASH ROM indicated by the DIPSWITCH.
dd: identifies the device which is responding.
F0 00 20 1c dd 04 02 ii F7
Provides an identification number for each keyboard to identify the number of keyboards and configure each
one separately. The first device is set to 0 and increments this number before passing the message to the next
device.
dd: not used in this command.
ii: device identification.
_________________________________________________________________________________________________________
CMK-1 Manual (Issue-1)
identifies the device which is responding.
first message in a restore sequence must have a block-count of 00 00.
number of bytes of original data transferred in this block.
8-for-7 coded bytes of data.
first message in a restore sequence must have a block-count of 00 00.
Page-70
October 20, 2004