Programming - Classic Organ Works CMK-1 User Manual

If the volume and expression controls are set to produce messages on the same MIDI channels, the volume control will
set the maximum range while the expression control will change the loudness level in the volume range.

Programming

The following chart lists different functions achievable using the piston pushbuttons and keyboard key-switches.
Table 11: Piston programming functions
Name
SOFT
REBOOT
SET MIDI
CHANNELS
FOR THE
KEYBOARD
CLEAR MIDI
CHANNELS
FOR THE
KEYBOARD
DEFAULT
VELOCITY
(if keyboard is
in non-velocity
mode)
_________________________________________________________________________________________________________
CMK-1 Manual (Issue-1)
Steps
st
Press the 1 piston Performs a soft reboot. This will restart the keyboard
from the left (SET)
st
and 1 piston from
the right
(CANCEL)
simultaneously
st
Hold the 1 piston Sets the output MIDI channels for the keyboard. For
from the left (SET) example, if we configure the keyboard to output on
st
and the 1 black channels 1, 3 and 5, then all MIDI events originating
key from the left
(C#1). Then select
any combination of
st
the 1 16 white
keys from the left
(C1 to D3).
Afterwards, release
the SET piston.
st
Hold 1 piston from
the left (SET) and
nd
2 black key from
the left (D#1).
Afterwards, release
the SET piston.
st
Hold the 1 piston
from the left (SET)
rd
and 3 black key
from the left (F#1).
Then press one of softest) and 127 (treble end: loudest). Keys pressed
the white keys and
release the SET
piston. relative to the extremes. The change in velocity level
Page-30
Function
and reload configuration data from the on-board
EEPROM.
from that keyboard will produce MIDI messages
transmitted on these three channels.
Clears the output MIDI channels for the keyboard.
If the keyboard is set to non-velocity mode, the
default velocity output of the keyboard can be
selected. This is accomplished by using the white
keys select a velocity level between 0 (bass end:
in between will produce a velocity level between 0
and 127 depending on the location of the key
between adjacent white keys is approximately 3.
Note that in the event multiple keys are pressed,
only the last one released will be registered by the
software.
October 20, 2004