Powermatic 64S Operating Instructions And Parts Manual page 17

2. Grounded, cord-connected tools intended for use
on a supply circuit having a nominal rating less than
150 volts:
•
This saw is intended for use on a circuit that has
an outlet that looks like the one shown in Figure 23(A).
•
A temporary adapter, which looks like the adapter
shown in Figure 23(B&C), may be used to connect
this plug to a 2-pole receptacle as shown in view (B) if
a properly grounded outlet is not available. The tem-
porary adapter should only be used until a properly
grounded outlet can be installed by a qualified electri-
cian.* The green-colored rigid tab or lug, extending
from the adapter, must be connected to a permanent
ground such as a properly grounded outlet box.
*This adaptor is not applicable in Canada.
3. Grounded, cord-connected tools intended for use
on a supply circuit having a nominal rating between
150-250 volts, inclusive:
•
This cord is intended for use on a circuit that has
an outlet that looks like the one shown in Figure 23(D).
Make sure the saw is connected to an outlet having
the same configuration as the plug. No adapter is avail-
able or should be used. If the saw must be rewired for
use on a different type of electric circuit, the rewiring
should be made by a qualified service personnel, and
after rewiring the saw should comply with all state and
local electrical codes and ordinances. See page 26
for 230V wiring diagram.
FIGURE 23
17