Table of Contents
Advertisement
INSTALLING THE DUST SHROUD
Tools Required
Small adjustable wrench
phillips screwdriver.
TIP: Since the dust shroud is installed from beneath,
aid from a helper to install the screws and tabs will
make this task much easier.
1.
From under the saw, position the dust shroud at
an angle so it fits through the opening between the
stand and the saw. Set the lip of the shroud on the top
side of the stand as shown in Figure 19.
2.
Attach two 3/16-24 x 5/8 pan head screws and
two 3/16 star washers to the tabs. Reach in from the
motor side of the saw and push the screws through
the holes provided in the stand.
3.
Attach two 3/16 nuts from the bottom side, and
with both tabs positioned over the lip of the shroud,
tighten both screws.
INSTALLING THE ON/OFF SWITCH
NOTE: The switch can not be mounted until the fence
and rails are mounted. Attach the switch under the
first screw from the left on the front rail, as shown in
Figure 20. The switch mounting bracket has a slot for
adjustment.
The table saw is equipped with a push-button switch
and safety key as shown in Figure 20. When the safety
key is inserted into the start button, the button cannot
be pushed in, thus preventing accidental starting of
the saw. It is recommended that the safety key be
placed on the machine whenever the machine is not
in use.
INSTALLING THE MITRE GAUGE
ASSEMBLY
1.
Mount the gauge body to the bar, making sure
the pins underneath the body fall in the holes in the
bar.
2.
Place the fiber washer on to the threaded rod,
and screw on the handle as shown in Figure 21.
3.
Slide the mitre gauge into the left hand slot on
the saw table.
FIGURE 19
FIGURE 20
FIGURE 21
15
Hide quick links:
Advertisement
Table of Contents
