Table of Contents
Advertisement
Push insert down into table opening. Verify that
insert lies flush with table surface by resting a
straight edge across it at various points. If insert is
not flush along its length, turn any of six set screws
to raise or lower that area of the insert.
Figure 9
NOTE: If while lowering blade, the points on the
anti-kickback pawls tend to catch in the seam
between table and table insert, slightly raise that
area of table insert above main table surface.
7.12 Installing and Removing Blade
A blade is not provided with this machine.
Model
industrial-grade low-friction corrosion-resistant
coating on the table and table extensions.
While the coating is durable, it can be damaged
if metal or other hard and/or sharp objects
strike,
gouge,
or
Significant damage to the coating may affect its
performance. Use care when installing and
removing saw blade.
Use care when working with or
around sharp saw blades to prevent injury.
Refer to Figures 10 and 11.
1. Disconnect machine from power source.
2. Remove table insert.
4. Raise blade arbor all the way up and set blade
tilt to 0°. Tighten handwheel locking knob.
5. Press arbor lock pin (C) and rotate arbor to
engage
pin
into
Simultaneously remove arbor nut (A); loosen
with arbor wrench if necessary.
6. Remove flange (B).
7. Install blade onto arbor, making sure the teeth
point downward toward front of saw.
8. Install flange (B) and nut (A).
9. Engage arbor lock (C) and tighten nut (A) with
provided arbor wrench.
PM1000T
has
an
scratch
the
surface.
slot
in
the
arbor.
Figure 11 (blade not provided)
7.13 Riving Knife
Refer to Figure 12.
To install riving knife:
1. Remove table insert.
2. Raise blade arbor all the way up and set tilt to
0° position.
3. Pull quick-release lever (G, Figure 12) to open
position. The clamp plate (F) is spring loaded
and will move away from the bracket (E),
leaving a gap.
13
Figure 10
Advertisement
Table of Contents
