Speakers Set - Yamaha AVR-S80 Service Manual

Hide thumbs Also See for AVR-S80:
Table of Contents

Advertisement

AVR-S80/NX-SW80

4. SPEAKERS SET

The input signal is automatically identified and switched in
the priority order of dts → DOLBY DIGITAL → AAC →
PCM AUDIO → Analog (A/D) according to the signal
detection.
The signals output from the DSP block are the same as 1.
DSP THROUGH: YSS 0dB.
MAIN: SMALL 0dB
Front Mix: 5ch
The analog switch settings for each sub-menu are as
shown in the table below.
Sub-menu
1
MAIN: SMALL 0dB
2
CENTER: NONE
3
LFE/BASS: MAIN
4
FRONT MIX: 5CH
LARGE: This mode is used with a speaker with high
bass reproduction performance (a large
unit). Full bandwidth signals are output.
SMALL:
This mode is used with a speaker with low
bass reproduction performance (a small
unit). The signals of 90Hz or less are mixed
into the channel specified by LFE/BASS.
NONE:
This mode is used with no center speaker.
The center content is reduced by 3dB and
distributed to MAIN L/R.
Reference data
INPUT: VIDEO 1 ANALOG (Both ch)
Sub-menu
1 MAIN: SMALL 0dB 1kHz/90Hz Both ch, -20 dBV
2 CENTER: NONE
3 LFE/BASS: MAIN
4 FRONT MIX: 5CH
24
CENTER SP REAR SP
LARGE
NONE
SMALL
LARGE
Input level
Volume
-10 dB
1kHz Both ch, -20 dBV
-10 dB
50Hz Both ch, -20 dBV
-10 dB
1kHz Both ch, -20 dBV
-10 dB
MAIN SP MAIN LEVEL LFE/BASS
LARGE
SMALL
0dB
LARGE
LARGE
0dB
SMALL
LARGE
0dB
LARGE
LARGE
0dB
6CH PRE OUT
FRONT L/R (1kHz) CENTER (1kHz)
- ∞
-16.5/-19.5 dBV
- ∞
-16.0 dBV
- ∞
- ∞
- ∞
-16.5 dBV
LFE/BASS: MAIN
SWFR
BOTH
MAIN
BOTH
RL/RR (1kHz)
SUBWOOFER (50Hz)
- ∞
- ∞
- ∞
- ∞
- ∞
-4.0 dBV
- ∞
- ∞

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avr-nx-sw80

Table of Contents