AVR-S80/NX-SW80
• Operation procedure of DIAG menu and
SUB-MENU
There are 15 MENU items, each of which has some SUB-
MENU items.
DIAG menu selection
Main unit: Select the menu using
(Reverse) keys of PRESET/TUNING.
Remote control unit: Select the menu using
and
(Reverse) keys. (in AMP mode)
SUB-MENU selection
Main unit: Select the sub-menu using DSP (Forward) key.
Remote control unit: Select the sub-menu using
(Forward) and
(Reverse) keys. (in AMP mode)
Keys of main unit
DIAG menu selection
• Functions in DIAG mode
In addition to the DIAG menu items, functions as listed
below are available.
• Input selection, Disc Direct (Input DVD/CD)
• Center/Rear/Sub-woofer level adjustment
• Muting
• Power on/off
• Master volume
* Functions related to the tuner and the set menu are not
available.
* It is possible to confirm Menu No.11 IF STATUS while
keeping the signal process (operation status) of each
DIAG menu by using the input mode key of the main
unit.
• Initial settings used to start DIAG
The following initial settings are used when starting DIAG.
When DIAG is canceled, these settings are restored to
those before starting DIAG.
• Master volume: -40dB
• Input: VIDEO 1
• Effect level: 0dB
• Audio mute: OFF
• Speaker setting: LARGE / BASS OUT = BOTH
• DIAG menu: DSP THROUGH (1. ANALOG BYPASS)
20
(Forward) and
(Forward)
SUB-MENU selection
Keys of remote control
DIAG menu selection
SUB-MENU selection
Need help?
Do you have a question about the AVR-S80 and is the answer not in the manual?
Questions and answers