Configuring A Static Lacp Link Aggregation Group - H3C S5500-EI series Operation Manual

Operation Manual – Link Aggregation
H3C S5500-EI Series Ethernet Switches
For a manual aggregation group containing only one port, the only way to remove
the port from it is to remove the aggregation group.
To make an aggregation group to function properly, make sure the selected states
of the ports on the both sides of the same link are the same.

2.1.2 Configuring a Static LACP Link Aggregation Group

Follow these steps to configure a static aggregation group:
Enter system view
Configure the system
LACP priority
Create a static LACP
aggregation group
Enter Ethernet port view
Configure the port LACP
priority
Assign the Ethernet port
to the aggregation group
Note that:
You can create a static aggregation group by changing the type of an existing
manual link aggregation group that contains no port.
An aggregation group cannot contain the following ports: RRPP-enabled ports,
ports configured with static MAC addresses or black hole MAC addresses, voice
VLAN-enabled ports, or 802.1x-enabled ports.
After you remove a static aggregation group, all the ports in the group are
dismissed from it, and LACP is disabled on the ports.
For a static LACP aggregation group containing only one port, the only way to
remove the port from the aggregation group is to remove the aggregation group.
To do...
system-view
lacp system-priority
system-priority
link-aggregation group
agg-id mode static
interface interface-type
interface-number
lacp port-priority
port-priority
port link-aggregation
group agg-id
Chapter 2 Link Aggregation Configuration
Use the command...
2-2
Remarks
––
Optional
32768 by default.
Changing system LACP
priority can affect the
selected/unselected state
of the ports in the group.
Required
––
Optional
32768 by default.
Changing port LACP
priority can affect the
selected/unselected state
of the ports in the group.
Required