DFI PT880-ALE User Manual page 72

3
BIOS Setup
3.1.5.8 MODEM Use IRQ
This field is used to set an IRQ channel for the modem installed
in your system.
3.1.5.9 Soft-Off by PWRBTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec Regardless of whether the Power Management
Instant-Off
3.1.5.10 Run VGABIOS if S3 Resume
When this field is set to Auto, the system will initialize the VGA
BIOS from the S3 state.
3.1.5.11 PWR Lost Resume State
Keep Off When power returns after an AC power failure,
Turn On
Last State When power returns after an AC power failure,
72
field is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the sys-
tem enters the Suspend mode. The purpose of
this function is to prevent the system from
powering off in case you accidentally "hit" or
pushed the power button. Push and release again
in less than 4 sec to restore. Pushing the power
button for more than 4 seconds will power off
the system.
Pressing and then releasing the power button at
once will immediately power off your system.
the system's power is off. You must press the
Power button to power-on the system.
When power returns after an AC power failure,
the system will automatically power-on.
the system will return to the state where you left
off before power failure occurs. If the system's
power is off when AC power failure occurs, it will
remain off when power returns. If the system's
power is on when AC power failure occurs, the
system will power-on when power returns.