DFI PT880-ALE User Manual page 52

3
BIOS Setup
Many disk diagnostic programs which attempt to access the boot
sector table will cause the warning message to appear. If you are
running such a program, we recommend that you first disable
this field. Also, disable this field if you are installing or running
certain operating systems like Windows
operating system may not install nor work.
3.1.2.3 CPU L1 & L2 Cache
This field speeds up the memory access. The default value is ena-
bled.
3.1.2.4 CPU L3 Cache
This field is used to enable or disable the CPU's L3 cache.
3.1.2.5 Hyper-Threading Technology (for Intel
with Hyper-Threading Technology)
This field is used to enable the functionality of the Intel
Pentium
appear only when using this processor.
3.1.2.6 CPU L2 Cache ECC Checking
The processors supported by the system board come with built-
in Level 2 cache. By default, ECC is enabled to check the Level 2
cache. If you are not using this function, set this field to Disabled.
3.1.2.7 Quick Power On Self Test
This field speeds up Power On Self Test (POST) after you power
on the system. When Enabled, the BIOS will shorten or skip
some check items during POST.
3.1.2.8 SATA or SCSI Card Boot
This field is used to select between booting from a SATA drive
and the drive connected to the SCSI card.
VIA 8237 SATA The drive connected to the SATA 1 or SATA
PCI SCSI Card The drive connected to the SCSI add-in card
52
®
4 Processor with Hyper-Threading Technology and will
2 connector.
that is installed in a PCI slot.
98/2000/ME/XP or the
®
® ®
Pentium 4 Processor
®