Connecting Speakers - Inter-m PA-612 Operation Manual

Connecting Speakers

Connecting Speakers
Before connecting speakers, disconnect the AC power cable. Note the proper connecting terminals as shown
below. Make certain that the total impedance is not less than the rated impedance indicated.
HIGH IMPED NCE SPE KER INST LL TION
- Please set up the unit according to the diagram below, be aware and monitor the voltage and impedance
of output terminal.
- Until the sum of the output up to 120W(PA-612) or 240W(PA-624), High impedance speakers can be
connected.
- Please do NOT load over 120W(PA-612) or 240W(PA-624) in total.
- Please do NOT use 4 output and High impedance at the same time.
- Please check wires not to short-circuit.
* In Western Hemisphere(North America, South America and Caribbean), the jack has only 3 terminals
because there is no 100V output.
* "Class 2 Wiring" means that TERMINALS provided the audio output power exceeds 10W per channel
under normal operating conditions or the apparatus is intended to be installed or interconnected in the
field by a SKILLED PERSON.
PUBLIC ADDRESS AMPLIFIER
*
PA-612
*
PA-624
PA-612/624
7