Front I/O Assemblies For Lff And Sff Chassis Using Thumbscrew Rack Ears - HP ProLiant DL180 Gen9 Service Manual

Select Reboot the System to exit the utility and resume the boot process.
8.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent
boot-up. Access the Network Options screen again to view this IP address for later reference.
Front I/O assemblies for LFF and SFF chassis using
thumbscrew rack ears
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 30).
o
If installed, remove the security bezel
4.
Remove the access panel
5.
Release the front I/O cabling from the server:
6.
Detach the ambient thermal sensor cable from its clip.
a.
Release the ambient thermal sensor cable from the front chassis cable clip.
b.
Disconnect the front I/O assembly cable.
c.
—
Front I/O cabling disconnection in an LFF chassis
To prevent damage to electrical components, take the appropriate anti-static
("Remove the security bezel
("Access panel" on page 37).
(optional)" on page 27).
Removal and replacement procedures 68