Remove the fan cage.
7.
Non-hot-plug drive carrier
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
3.
Remove the drive carrier.
4.
To replace the component, slide the component into the bay until it clicks.
Non-hot-plug drive
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the security bezel
(optional)" on page 27).
Removal and replacement procedures 34