System Board - HP ProLiant DL180 Gen9 Service Manual

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 30).
3.
If installed, remove the security bezel
4.
Remove the right quick-release latch rack ear screws, and then move the ear away from the right side
5.
of the pull tab cage.
Remove the pull tab cage.
6.
To replace the component, reverse the removal procedure.

System board

("Remove the security bezel (optional)" on page 27).
Removal and replacement procedures 73