4-Bay And 8-Bay Lff Non-Hot-Plug Drive Cable Assemblies - HP ProLiant DL180 Gen9 Service Manual

Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 30).
o
If the locking latch is locked, use a T-15 Torx screwdriver to unlock the latch.
4.
Open the locking latch.
5.
The access panel slides back, releasing it from the chassis.
Lift and remove the access panel.
6.
To replace the component, reverse the removal procedure.
4-bay and 8-bay LFF non-hot-plug drive cable
assemblies
WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
3.
Remove all drives
4.
page 34).
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Remove the security bezel
("Non-hot-plug drive" on page 34) and drive carriers
(optional)" on page 27).
("Non-hot-plug drive
Removal and replacement procedures 38
carrier" on