Before proceeding, verify the server is in standby mode by observing that the system power LED is amber.
Extend the server from the rack
WARNING:
adequately stabilized before extending a component from the rack.
If the rear panel cables are not secured by a cable management arm, do the following:
1.
Power down the server (on page 27).
a.
Disconnect all peripheral cables from the server.
b.
Disconnect each power cord from the server.
c.
In a server that uses thumbscrew rack ears, loosen the captive thumbscrews that secure the server
2.
faceplate to the front of the rack, and then slide the server out of the rack.
In a server that uses quick-release latch rack ears:
3.
Open the latches on both sides of the server.
a.
If necessary, use a T-25 Torx screwdriver to loosen the shipping screws.
b.
To reduce the risk of personal injury or equipment damage, be sure that the rack is
Removal and replacement procedures 28