General Assembly Instructions - Vacmaster VQ1220PF Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

3.1 Verify that the power cord is disconnected from the power outlet.(As show in
fig.1)
3.2. Undo the latches. (fig.2)
3.3. Lift the power head off the container. (fig.3)
3.4. Remove the contents from inside the container; make sure you have all
contents as listed. (fig.4)
3.5. Insert the casters into the socket on to bottom of the container and apply
pressure until castors snap into place (fig.5)
3.6. Your vacuum comes ready for dry vacuum cleaning with dust filter. If the
dust filter is not installed, refer to page 13 for filter installation. (fig.6）
3.7. Optional, for improved dust bag, fit dust bag flange onto the inlet stub,
taking care not to damage the bag. (fig.7)
3.8. For wet vacuum cleaning, install the supplied foam filter. If foam filter is
not installed, refer to page 14 for filter installation (fig.8)
3.9. Place the power head back on the container, and secure into place using
the 2 side latches. (fig.9 & fig.10)
3.10. Insert the locking end of the hose into the port of the container and turn to
lock in to place. (fig.11)
9