Installing & Cleaning Foam Sleeve Filter - Vacmaster VQ1220PF Operator's Manual

8.6. Carefully remove the dust filter from the filter cage. (fig. 3) Clean the filter by
gently tapping or brushing dirt off. Cleaning should not be done indoors in
living areas.
8.7 Use a mild soap and water solution to wash dust filter and rinse with clean
water. (fig. 4)
8.8 Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
INSTALLING & CLEANING FOAM FILTER
Installing Foam Filter
9.1. Verify that the power cord is disconnected from the outlet
9.2. Remove power head and place in upside down position. Follow instructions to
remove dust filter.
9.3. Carefully slide foam filter down over the filter cage making sure the whole cage is
covered. (fig.1 & 2)
9.4. Replace the power head on to the container.
Cleaning Foam Filter
9.5. With the removed power head in the upside down position, carefully remove
foam filter. (fig.3)
9.6. Use a mild soap and water solution to wash foam filter and rinse with clean
water. (fig.4)
9.7. Allow filter to air dry before installing and using again.
14