Vivotek FD8167 User Manual page 7

Hardware Reset
Reset Button
The reset button is used to reset the system or restore the factory default settings Sometimes
resetting the system can return the camera to normal operation If the system problems remain
after reset, restore the factory settings and install again
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default Upon successful restore, the status LED will blink
green and red during normal operation
Micro SD/SDHC/SDXC Card Capacity
This network camera is compliant with Micro SD/SDHC/SDXC 8/16/32/64GB and other
preceding standard SD cards
LED Definitions
Item LED Status
1 Steady Red
Red LED off
2 Steady Red + blinking
LED on for 1 sec and off for another)
Steady Red +
3 Blinking Red
every 1 sec (Red
LED on for 1 sec and off for another)
4 Blinking Red
every 015 sec
Green every 1 sec
Green LED off
every 015 sec + Blinking
LED on for 015 sec and
every 015 sec + blinking
Description
Power on and system booting
Powered off
(Green Network heartbeat
Network disconnected
Green Upgrading firmware
Green
Green Restoring defaults
VIVOTEK
User's Manual - 7