Connecting And Using A Second Stacker - Toshiba E-studio 1105 Operating Instructions Manual

Connecting and Using a Second Stacker

This section explains how to connect and use a second stacker.
If you install a second stacker, paper collection can continue without interruption when the first stacker
becomes full. While one stacker is collecting paper, you can unload and reload the handcart of the other
stacker.
• To switch output trays automatically, "Output Tray" must be set to [Auto Change] in [Output Tray
Setting] under System Settings.
• When a second stacker is installed and "Output Tray" is set to [Auto Change], the output tray will
change automatically in the following cases:
• Whenever the receiving stacker becomes full and the other stacker tray is empty.
• If the settings of the receiving stacker are changed from the receiving main control panel or a
connected computer and the other stacker tray is empty.
• If "Multi-job Output Method to Stacker" is set to [Do not Stack Jobs] and the other stacker tray
is empty when a new job begins.
• Even if "Output Tray" is set to [Auto Change], output stops if the other stacker tray is not empty.
• If a paper jam occurs when a second stacker is installed, the Paper Jam button of the stacker in which
the paper jam occurred lights red.
Connecting and Using a Second Stacker
7
159