If The Timer Programming Did Not Complete Correctly - FUNAI WL6D-M102 Owner's Manual

Note
• If you have not set the clock, the clock setting window will
appear instead of the Timer Programming list. Continue
from " Clock" on page 61 before programming the timer.
• Press [K \ L] to move the cursor in "Timer Programming"
list.
• If a basic recording or One-touch Timer Recording is in
progress on one component (e.g. VCR) and the timer
recording set for the other component (e.g. DVD) is about to
begin, the unit automatically switches to the programmed
channel for timer recording 2 minutes before the
programmed starting time, and the recording in progress (for
VCR) will be cancelled UNLESS their recording channels
are the same. If their recording channels are the same, the
timer recording will start without cancelling the recording
currently in progress. In this case, the recording of the same
channel will be made on both DVD and VCR.
• Cancel the timer-standby mode by pressing [TIMER SET] to
use the component currently in timer-standby mode. When
finished operating, press [TIMER SET] to resume the timer-
standby mode.
• In the timer-standby mode, you can turn on the power and
use the component (VCR or DVD) which is not currently
timer-programmed.
Checking, Cancelling or Correcting the
Timer Programming Information
1
Press [TIMER SET] to cancel the timer-standby
mode.
2
Press [TIMER PROG.].
"Timer Programming" list will appear.
3
A) To delete the timer programme:
1) Select the programme you want to delete using
[K \ L], then press [ENTER].
2) Select "Delete" using [K \ L], then press [ENTER].
Confirmation window will appear.
3) Select "Yes" using [K \ L], then press [ENTER].
B) To correct the timer programme:
1) Select the programme you want to correct using
[K \ L], then press [ENTER].
2) Select "Programme Change" using [K \ L], then press
[ENTER].
3) Correct the timer programme by using [K \ L \ 0 \ 1],
then press [ENTER].
4
Press [TIMER PROG.] to exit.
5
Press [TIMER SET] to return to the timer-
standby mode.
To check the timer programming in progress
Press [TIMER PROG.].
Note
• If a timer recording is proceeding, that programme is
highlighted in red. In such a case, you cannot select any
other programmes.
• When you check the timer programming in progress by
pressing [TIMER PROG.] during operations of the
component (DVD or VCR) which is not currently used for the
timer recording, the programme will not be highlighted. In
this case, you cannot select other programmings.
Stop the Timer Recording in Progress
On the front panel:
Press [STOP C].
On the remote control:
1 Press [STOP C].
2 Select "Yes" using [K \ L], then press [ENTER].
If the Timer Programming did not
Complete Correctly
The error number appears on "Timer Programming" list.
Timer Programming
Date
E40 17/05
New Programme
The error programme will be displayed in grey with an error
number.
10:00 SAT 17/05
Start End CH
7:00 9:00 AV1
1/1
EN
27