Step 2 Set Jumpers; Step 3 Install Ddr Sdram System Memory - Shuttle FS51 User Manual

Step 2.
Set Jumpers
This mainboard is jumperless! The default jumper settings have been set for
the common usage standard of this mainboard. Therefore, you do not need
to reset the jumpers unless you require to clear the CMOS.
For first-time DIY system builders, we recommend that you do not change the
default jumper settings if you are not totally familiar with the mainboard
configuration procedures. The factory-set default settings are tuned for opti-
mum system performance. For the advanced users who wish to customize
their system, section 3.2 Jumper Settings will provide detailed information
on how to configure your mainboard manually.
Step 3
Install DDR SDRAM System Memory
To install memory, insert DDR SDRAM memory module(s) in DIMM slot(s).
Note that DDR SDRAM modules are directional and cannot be inserted into
the DIMM slots unless properly oriented. After the module is fully inserted
into the DIMM slots, lift the clips of both sides of the DIMM slot to lock the
module in place.
DDR SDRAM
- 14 -