Cleaning The Main Charger Unit - Kyocera Mita WP31C Operation Manual

5.3 Cleaning the Printer
5.3.2

Cleaning the Main Charger Unit

The main charger unit needs to be cleaned periodically as it gets contaminated with dioxide
after a long usage. The main charger is comprised of two main parts — the wire and the grid
— which should be cleaned separately as instructed below.
To clean the main charger unit, proceed as follows:
1
Open the front cover.
2
First we clean the main charger wire. Grasp the tab of the cleaning knob
(green-colored). Gently pull the cleaning bar out and push it back in. Repeat this 3 to
5 times.
Figure 5-16
3
Next, we clean the main charger grid. Take the grid cleaner out of the toner kit. Take
the grid cleaner out of the protective bag and remove the cap.
Figure 5-17
The pad of the grid cleaner contains water. Clean the grid quickly so
that the pad may not dry off.
Note
Cleaning knob
5-12
Cap
Grid Cleaner