Original/Paper-Related Items; Image Trouble - Toshiba E-Studio 2006 User Manual

6.TROUBLESHOOTING
 Original/Paper-related items
Phenomenon
Paper misfeeds.
Multiple feeding occurs.
 Image trouble
Phenomenon
The copy image is light.
The copy image is dark.
The copied image is stained.
The copy image is fogged.
The copy image is partially
missing.
The copy image has black
streaks in a horizontal direction.
Usual cause
The paper is unsuited for the
equipment.
The paper size is not registered
properly in the equipment.
Misfed paper is located in a place
you cannot see easily.
There is no gap between the side
guides and paper in the drawer,
or the gap is too wide.
Sheets of paper clinging to each
other.
Usual cause
Toner has run out.
The copy density is set lighter.
The copy density is set darker.
The Platen Cover or the
Reversing Automatic Document
Feeder is not lowered fully.
The original glass or platen sheet
is dirty.
The copy density is set darker.
Highly transparent originals such
as overhead transparencies or
tracing paper are used.
There is a slight gap between the
original glass and the original.
The paper is damp.
The size or direction of the paper
and the original, or the
reproduction ratio is not set
properly.
The margin for binding is too
wide.
The charger is dirty.
Countermeasure
Check if the paper is acceptable.
 P.20 "Paper types not acceptable"
Register the paper size properly.
 P.28 "Preparation 3 - Registering Paper Size and Type"
See the message on the LCD screen to recheck the position
where the paper misfeed has occurred.
 P.111 "Paper Misfeed"
Adjust the gap between the side guides and the paper
properly.
 P.21 "Loading paper in the drawer/Paper Feed Unit"
Fan the paper well and place it again.
Countermeasure
Replace the toner cartridge if the "TONER EMPTY" message
appears on the LCD screen.
 P.120 "Replacing Toner Cartridge"
Make the density darker if you use the manual copy density
mode.
Make the density lighter if you use the manual copy density
mode.
Lower it fully to block outside light.
Clean them.
 P.126 "Regular Cleaning"
Make the density lighter if you use the manual copy density
mode.
Place a blank plain sheet of paper, the same size as the
original or larger, over the original.
Lower the Platen Cover or the Reversing Automatic
Document Feeder fully so that the original will contact with the
original glass.
Replace with dry paper.
Use paper of the same size as the original or set the
reproduction ratio suitable to the paper size.
Adjust the image shift value again.
 P.50 "Shifting the pages to the right or left"
Clean the charger.
Before Calling Service Technician
6 TROUBLESHOOTING
123