1 PREPARATION
Components
Front/Left side/Inner side
1. Reversing Automatic Document Feeder (RADF) (optional)
The stack of originals is scanned one sheet at a time. Both sides of the originals can be scanned. A maximum of 50
2
sheets (80 g/m
or 20 lb. Bond) can be placed in one go. (The maximum number of sheets that can be set may vary
depending on the media type of the originals.)
P.111 "Paper Misfeed"
2. Platen sheet
P.126 "Regular Cleaning"
3. Original glass
Place the book-type originals and special paper such as overhead transparencies or tracing paper, as well as plain
paper.
4. Control panel
Make settings to use the various functions on this equipment.
P.14 "Control panel"
5. Toner cartridge
For the recommended toner cartridges, refer to the Safety Information.
P.120 "Replacing Toner Cartridge"
6. Front cover
Open this when you replace the toner cartridge.
P.120 "Replacing Toner Cartridge"
7. Drawer
Place up to 250 sheets of plain paper (80 g/m
P.21 "Loading paper in the drawer/Paper Feed Unit"
8. Paper Feed Unit (optional)
Use the Paper Feed Unit to add the second drawer. A maximum of 250 sheets (80 g/m
can be placed in one go.
9. Power switch
Turns the power ON or OFF.
P.17 "Preparation 1 - Turning Power ON"
10. Paper exit stopper
Stops large paper from sliding out of the receiving tray.
11. AC-IN terminal (rear)
Connect the power cable supplied with the equipment.
12. Receiving tray
10
Components
15
14
13
12
11
10
9
2
or 20 lb. Bond).
1
2
3
4
5
6
7
8
2
or 20 lb. Bond) of plain paper