Table of Contents
Advertisement
25.0 Start/Stop device
Once the HydroMace 3000 has been configured and tested it is ready to be
started so that measuring and logging is initiated.
WarNINg - If the device is NOt started measurements will NOt occur
From the main menu click "Start device" and you will
be asked "Are you sure?". Click "Yes" and the device
will start and you will be returned to the main menu.
You will notice that the "Start Device" has changed to
"Stop device" in the main menu.
To enable changing of settings, access of real-time data and resetting totals,
the HM 3000 must first be stopped.
From the main menu click "Stop device" and you
will be asked "Are you sure?". Click "Yes" and the
device will stop and you will be returned to the
main menu. You will notice that the "Stop Device"
has changed to "Start device" in the main menu.
26.0 Disconnect
From the main menu click "Disconnect" and
you will be asked "Are you sure?". Click "Yes" and
the device will be disconnected and you will be
returned the start up menu. Click on "File>Exit"
to shut down FloCom
.
+
WarNINg - If FloCom
+
is not disconnected from the device excess
current will be drawn from the main battery
82
SeCtion b SoFtware Manual
27.0 View totals
From the main menu click "View totals" and the "Flow volume totals"
dialogue box will appear.
This dialogue box lists all the
accumulated flow channels and
their respective totals and units.
If the HM 3000 has not been started, the "Set/Reset" button will be active
and the totalised reading can be changed.
It is strongly advised to download the logged data prIOr to
resetting the total value
1. Highlight the channel you wish
to reset by clicking on it's name.
2. Click "Set/Reset" and the "Set
total value" dialogue box will
appear.
3. Enter the "New value" into the
field and click "Set value". The new
value will then be displayed in the
"Flow volume totals" dialogue box.
Double check that this value is COrreCt
4. If the HM 3000 has not been stopped, the "Set/Reset" button will be
greyed out and the total/s will not be re-settable.
5. To update the reading whilst flow is accumulating, click "Refresh".
RetuRn to toC
RetuRn to toC
MaCe HydRoMaCe 3000 Product Manual
83
Advertisement
Table of Contents
