Nimbus Water Systems WaterMaker Five WM5-50 User Manual page 9

Note: This faucet requires a 1¼" opening in the sink or countertop.
1. Locate the faucet parts bag and arrange the parts on the
countertop in the sequence shown.
2. The last part in the sequence, the quick connect adapter (6),
will be found in the smaller parts bag.
3. Locate the piece of white tubing. Pull the white, black and
blue tubing up through the faucet hole in the sink.
4. Insert polished faucet base and rubber seal onto base of
faucet.
5. Push the 1/4" black drain tubing attached to the system onto
the smaller 1/4" barb located on the faucet base.
6. Push the 3/8" white tubing onto the larger 3/8" fitting located
on the faucet base.
7. Slide white plastic spacer open-end-up onto the threaded
faucet stem (2). Note: This spacer may be omitted if faucet is
installed in a granite countertop (or countertop with similar
thickness).
8. Loosely thread the 3/8" washer (3), the serrated washer (4)
and mounting lock nut (5) onto the threaded stem. Leave enough
space for the slotted washer which will be used in step 11.
9. Thread faucet quick-connect adapter (6) on to threads of
faucet stem. NOTE: This connection should be hand-tightened only.
Push one end of 3/8" blue tubing into 3/8" connection.
10. Push the tubing down into the faucet hole and position the
faucet to the approximate orientation.
11. From underneath the sink, slip the slotted washer (1) between
the white plastic spacer and the sink. Check the orientation of
the faucet on the sink. Securely tighten the mounting nut with a
wrench.
12. If necessary, firmly insert spout assembly into the top hole of
faucet body (approximately 1/4"). You may swivel the faucet left or
right.
Push Handle Airgap Faucet
42445 Avenida Alvarado, Temecula, CA 92590
(800) 451-9343 · www.nimbuswater.com
Installation Videos
www.youtube.com/
nimbuswaterusa
Faucet to drain saddle
(3/8" white tubing)
Metal base plate
Rubber seal
1
2
3
4
5
6
System to airgap drain
(1/4" black tubing)
Product water
(3/8" blue tubing)
9