Husqvarna 2011 WR 300 Workshop Manual page 319

Tail light replacement
Remove the tail light as follows:
- Loosen the two screws (1) under the rear mudguard.
- Extract the tail light (2) and disconnect the connector (3).
Once the tail light has been replaced, reverse the above procedure to reas-
semble.
Be careful not to overtighten the screws.
Number plate bulb replacement
- Loosen screw (1) and remove the number plate bulb (2) from the mud-
guard.
- Extract the bulb holder (3) with the bulb (4) from the housing.
- Pull the bulb (4) to detach it from bulb holder.
Once the tail light has been replaced, reverse the above procedure to reas-
semble.
8000H1605 (07-09)
(01-2011) 8000H1605 (07-09)
IMPIANTO ELETTRICO IMPIANTO ELETTRICO
ELECTRIC SYSTEM
ELECTRIC SYSTEM
INSTALLATION ELECTRIQUE
INSTALLATION ÉLECTRIQUE
ELEKTRISCHE ANLAGE
ELEKTRISCHE ANLAGE
INSTALACION ELECTRICA
INSTALACION ELÉCTRICA
+-
1
1
H06503
3
2
H06504
2
1
H06505
3
4
H06506
M.5
A.1
M.29