Table of Contents
Advertisement
Raising Antenna to Operating Position
Turn elevating crank clockwise in "UP"
direction until some resistance to turning is noted
(about 13 turns). Antenna is now in operating
position.
Turn amplifier power switch "ON" to receive TV
signal.
Rotating Antenna for Best Picture
Make sure antenna is in the "UP" position.
Pull down on directional handle using both hands
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counter-clockwise) in
"DOWN" direction until resistance is noted
(about 13 turns). Antenna is now locked in travel
position. Turn amplifier power switch "OFF".
CAUTION
To avoid equipment damage, always
align directional handle to DOWN position
before lowering. Never partially raise or
lower antenna. Antenna must be raised
fully up into operating position or lowered
fully down into travel position.
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch located on a switchplate inside the front
overhead entertainment center cabinet.
An indicator light will glow when the switch
is on and the signal amplifier is active.
Power indicator
glows when signal
amplifier is active
TV Signal Amplifier Power Switch
(with 12-volt outlet and coaxial jack on wall plate
in front overhead entertainment compartment)
Checking Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter. Signals may vary from strong to no
usable signal at all. We recommend that the TV
system be checked out in an area known to have
good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
SECTION 8 -
ENTERTAINMENT
Push On-Off
8-5
Advertisement
Table of Contents
