Table of Contents
Advertisement
SUSPENSION ALIGNMENT
AND TIRE BALANCE
The front suspension and steering system of
this vehicle was factory aligned using highly
accurate equipment prior to delivery to the
dealership. However, alignment should be
checked and adjusted after you have fully loaded
the motor home according to your personal
needs. Thereafter, the alignment should be
periodically inspected to help prevent uneven tire
wear.
Any excessive or abnormal tire wear may
indicate worn or misaligned suspension or
steering, unbalanced tire, or other tire/suspension
problem.
Alignment can be affected by worn steering/
suspension parts or by incidents which happen
during driving, such as hitting a curb, pothole, or
railroad track, etc. Improper alignment can cause
tires to roll at an angle and wear unevenly. It may
also cause the vehicle to "pull" to the right or left.
Have your dealer inspect your vehicle's
suspension and steering components periodically
for misalignment or wear.
Out-of-balance tires will not roll smoothly and
can lead to vibrations and uneven tread wear,
such as cupping and flat spots. Tires may need to
be balanced if uneven wear is detected or if ride
comfort decreases noticeably.
Further Information
See the chassis manual in your InfoCase for
further information.
LIGHTS
All exterior lights should be checked for
proper operation each time the vehicle is
prepared for a trip. Any bulbs which fail to light
should be checked and replaced, when necessary,
with a new bulb of the same size. A failure of
more than one light, such as both taillights not
operating, may indicate a burned out fuse. Check
fuse and replace with one of the same rating
when necessary. If a fuse is not the cause of the
problem, the wiring system should be checked
immediately by an authorized service center.
DRIVING YOUR MOTOR HOME
Further Information
Refer to the chassis manual in your InfoCase
for further information.
CIRCUIT BREAKERS AND
FUSES – CHASSIS/DASH
AUTOMOTIVE 12-VOLT
The 12-volt automotive fuses and breakers are
conveniently located behind the panel beneath
the left end of the dash in front of the driver's
seat.
The circuit breakers will pop outward if they
are tripped. Simply push in to reset.
Always replace plug-in blade fuses with ones
of the same size and amperage rating/color.
See your chassis manual for further
information about chassis supplied fuses.
Automotive Fuse/Breaker Panel
(Located beneath left end of dash)
SECTION 3 -
3-13
Advertisement
Table of Contents
