Remote Setup Mode - LG LE2104 Owner's Manual

Remote Setup Mode

You can set the DVR of a selected site name in the remote
setup tab via the network.
Camera / Display Setup
Camera Setting
1. Select a channel for settings.
If you want to block a channel from other users, mark
up the convert option. The marked up channels are
displayed "LG logo" on the live windows for POWER or
NORMAL user.
2. Enter the new channel name.
3. Select input audio channel.
4. Set the PTZ control options.
• Port: Select the connected data port of the RS-
422/485 terminal on the rear panel.
• Control ID: Select the PTZ camera ID from 0 to 255.
Make the same settings as the PTZ camera.
• Protocol: Select the protocol supported by PTZ
camera.
• Baud Rate: Select the communication speed.(1200,
2400, 4800, 9600 or 19200)
5. Set the motion options.
50
• Sensitivity: Set the sensitivity level for the created
motion detection area. Sensitivity can be set from
0 to 10.
• Relay Output: Select the number of the RELAY-OUT
terminal for the output alarm signal when motion is
detected.
• Area: The factory default of the Motion detec-
tion area is set as the whole area. You can change
the area by using mouse on the preview window
screen.
- Select area: Click one point with the left mouse
button and drag & drop to the end point.
- Clear area : Click the start point with the right
mouse button and drag & drop to the end point.
Notes:
• If you want to display the grid, mark up the [Show Grid]
option.
• If you want to select the entire area, click the [Set All]
button or click the [Clear All] button to cancel the
selected area.
Recording Settings
1. Click the [Recording] button.
The recording setting window appears.
2. Set each option using the mouse (See page 24).
3. Click the [OK] button to confirm the settings.
Sensor Recording Settings
1. Click the [Sensor Recording] button.
The sensor recording setting window appears.
Client program