LG LS300N-D1 Instruction Manual

LG LS300N-D1 Instruction Manual

Color video camera

Advertisement

Quick Links

CAUTION
RISK OF ELECTRIC SHOCK �
DO NOT�OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
dangerous voltage within the product's
enclosure that may be of sufficient magni-
tude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and mainte-
nance (servicing) instructions in the litera-
ture accompanying the product.
FCC
FCC WARNING: This equipment may generate or
use radio frequency energy. Changes or modifications
to this equipment may cause harmful interference
unless the modifications are expressly approved in the
2
Color Video Camera
Instruction Manual
Before installing, operating or adjusting this
product, please read this instruction booklet
carefully and completely.
instruction manual. The user could lose the authority
to operate this equipment if an unauthorized change
or modification is made.
REGULATORY INFORMATION: FCC Part 15
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful inter-
ference when the equipment is operated in a commer-
cial environment.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense.
A suitable conduit entries, knock-outs or glands
shall be provided in the cable entries of this prod-
uct in the end user.
Caution: Danger of explosion if battery is incor-
rectly replaced. Replaced only with the same or
equivalent type recommended by the manufac-
turer. Dispose of used batteries according to the
manufacturer's instructions.
LS300N-D1
Models :
LS300P-D1
LS300N-B1
LS300P-B1
LS300P-C1

Advertisement

loading

  Related Manuals for LG LS300N-D1

  Summary of Contents for LG LS300N-D1

  • Page 1 Color Video Camera Instruction Manual LS300N-D1 Models : LS300P-D1 LS300N-B1 LS300P-B1 LS300P-C1 Before installing, operating or adjusting this product, please read this instruction booklet carefully and completely. instruction manual. The user could lose the authority CAUTION to operate this equipment if an unauthorized change RISK OF ELECTRIC SHOCK �...
  • Page 2 • Holes in metal, through which insulated wires Disposal of your old appliance pass, shall have smooth well rounded surfaces or 1. When this crossed-out wheeled bin shall be provided with brushings. symbol is attached to a product it means the product is covered by the European Warning: Do not install this equipment in a confined Directive 2002/96/EC.
  • Page 3: Cautions For Safe Operation

    Important Safety Instructions 9. Do not defeat the safety purpose of the polar- ized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety.
  • Page 4: Table Of Contents

    Models ........................ 7 Operating Controls and Their Functions ............8-9 OSD Menu ....................10-25 AREA Setting ....................26 Specifications ....................27-28 Models Models Signal System Power LS300N-D1 NTSC DC 12V DC 12V LS300P-D1 AC 230V LS300P-C1 DC 12V / AC 24V LS300N-B1...
  • Page 5: Osd Menu

    Lens Mounting C/CS adjustment lever C/CS adjustment lever 1. Loosen the C/CS adjustment lever 2. Hold up the lever to change the mount to CS / Hold down the lever to change the mount to C 3. Tighten the C/CS adjustmet lever CAUTION Be cautious not to use Auto Iris Lens with over 30mA.
  • Page 6: Osd Menu

    OSD MENU - Setting Settings can be made using the 5 buttons POWER UP BUTTON VIDEO located on the back of the camera. LEFT BUTTON 1. Please press the SETUP button. SETUP DC ELC VIDEO - Settings can now be made. DOWN BUTTON RIGHT BUTTON The SETUP menu is displayed on the monitor.
  • Page 7 OSD MENU - SHUTTER Please select the shutter mode by pressing the LEFT or RIGHT button. • AUTO : Please select ‘AUTO’ and then press the SETUP SETUP button to ‘AUTO’ the setting. Auto Control of the shutter speed can be achieved. LENS Adjust range : 0 ~ 255 steps SHUTTER...
  • Page 8 OSD MENU - AGC(Auto Gain Control) Please select the mode you wish to operate by pressing the LEFT or RIGHT button. SETUP AGC CONTROL LENS SHUTTER FIXED AGC GAIN WHITE BAL. FUNCTION ADJUST EXIT : RETURN • The BRIGHTNESS can be adjusted within the range of 0 ~ 255 steps. * If AGC OFF, DAY &...
  • Page 9 OSD MENU - FUNCTION > ID Setup 1. Please position the highlight to point to 'FUNCTION' on the SETUP menu by using the UP and DOWN buttons. 2. Please select the mode you wish to operate by pressing the UP or DOWN button. ID SETUP FUNCTION CAMERA ID...
  • Page 10 OSD MENU - FUNCTION > DAY & NIGHT Please select the mode you wish to operate by pressing the LEFT or RIGHT button. • AUTO : The camera selects black and white mode. FUNCTION If the picture is dark, on color mode if the picture is bright enough.
  • Page 11 OSD MENU - FUNCTION > Motion Detection Please select the area you wish to observe from the 64 areas in Area selection mode. FUNCTION Motion ICON CAMERA ID Motion Detection MIRROR DAY NIGHT AUTO MOTION PRIVACY Please select 'ON' and then press the SETUP GAMMA 0.45 button to MOTION the setting.
  • Page 12 OSD MENU - FUNCTION > GAMMA Select a GAMMA value. FUNCTION • Select [GAMMA] option on the [FUNCTION] screen. CAMERA ID • Press LEFT or RIGHT button to select a GAMMA. MIRROR To control the brightness, DAY NIGHT AUTO '0.05(increase)' to '1.00(decrease), USER' MOTION PRIVACY GAMMA...
  • Page 13: Area Setting

    OSD MENU - ADJUST ADJUST SETUP CONTRAST LENS SHUTTER FIXED SHARPNESS CB_GAIN WHITE BAL. FUNCTION ADJUST CR_GAIN EXIT • CONTRAST : The CONTRAST can be adjusted within the value of 0~255 steps. • SHARPNESS : The outline of the video image becomes cleaner and more distinctive as the level of SHARPNESS increases.
  • Page 14: Specifications

    Specification Model LS300N-D1 LS300P-D1 Signal System NTSC Total/Effective Pixelsg 410K / 380K 470K / 440K Pick-Up Device 1/3-Inch interline Color CCD (Super HAD) Lens C/CS Mount Signal Process Digital Signal Process Scanning System 2 : 1 Inerlace Sync. System Automatic Internal Scanning Frequency 59.94 Hz(VD)
  • Page 15 P/NO : MFL61949101...

This manual is also suitable for:

Ls300p-d1Ls300p-c1Ls300p-b1Ls300n-b1