LED TEST
This test checks if each of the LEDs illuminates.
1. When the DM-24 switches into the LED TEST mode, a pop-
up message, as shown below, appears and all the LEDs
should illuminate.
They illuminate at the same time if the meter bridge (MU-
24) is connected.
2. Press a cursor key to return to the DIAG menu screen. If all
the LEDs are in order, the LED TEST item is check marked.
You can press SHIFT + ENTER during ALL LED TEST.
Then the next pop-up message will appear and the LEDs will
illuminate one at a time in sequence. Pressing a cursor key
brings you back to the DIAG menu screen.
(This test does not run on the meter bridge.)
8
TASCAM DM-24